Plastic Bird Spikes Materials and Coating Guide

Two plastic bird spikess that look identical on the bench can have a fifteen-year gap in service life, and almost all of that gap sits in two decisions: which grade was used, and how the surface was prepared before coating.

This guide covers both, in the order that matters.

Base material

One-piece moulded polycarbonate base and pins, UV-stabilised is the starting point. The grades normally offered are:

• virgin PC with UV package (standard)
• economy PC (indoor / sheltered use)
• crystal clear base
• grey base for stone façades

Reading those options properly matters more than it sounds. A lower grade is not automatically a worse part — it is a part with a shorter life in a given environment. The question is always “shorter than what, and in which environment”.

Corrosion: the mechanism you are designing against

Two things happen to this product outdoors, and they are different problems:

• Atmospheric corrosion, driven by time-of-wetness, chloride and pollutant load. Coastal air is the aggressive case; the practical threshold many operators use is about 5 km from salt water.
• Galvanic corrosion, which appears where two different metals are in contact in the presence of moisture. On this product the risk sits at bolted and crimped interfaces.

The second is the one buyers underestimate, because it can be introduced by a change that looks like an improvement — using a stainless fastener on an aluminium body, for example, without an isolating washer.

Surface treatment options

moulded colour throughout — no painting; clear and grey are the two standard colours

How to specify them so they mean something:

1. State a measured requirement, not a process name. Thickness or mass per unit area, with the test method.
2. State where it is measured. A single reading in the middle of a flat face says nothing about a cut edge or a bend.
3. State the acceptance rule for damage. Some handling marks are inevitable; the specification should say which ones are rejects.
4. State the standard the coating must satisfy, and ask for the test record with the shipment.

Service life in different environments

A practical way to think about the options:

• Inland, dry, sheltered — the base specification (virgin PC with UV package (standard)) is normally sufficient for a fifteen-year design life.
• Inland, exposed, wet — specify the coating rather than the grade: moulded colour throughout — no painting.
• Coastal, within about 5 km of salt water — expect to move up a grade (grey base for stone façades) and to specify a salt spray test with a defined duration.
• Chemical, industrial or de-icing exposure — treat the site as coastal plus, and get the environment written into the specification rather than left to the supplier to guess.

Evidence to ask for

Claims about materials and coatings are cheap; evidence is not. Ask for:

1. Mill certificate or grade declaration for the base material.
2. Coating thickness or mass measurements per batch, with the test method.
3. Salt spray test report where the product is specified for a corrosive environment.
4. Where relevant to this product: pin pull-off ≥ 30 N; UV ageing 2000 h with colour-retention check; impact test at −20 °C (no brittle fracture).

The material-related failures to design out

• Pins snapping in cold weather — PC replaced with acrylic or recycled resin to cut cost — stays clear but goes brittle below about −10 °C
• Base warping on hot roofs — heat deflection temperature too low; dark grey bases on black membrane roofs see surface temperatures above 70 °C
• Pins splaying open — wall thickness at the pin root too thin; the spread starts within weeks on windy exposures

Note that none of these are visible at goods-in. They are design and specification failures that become service failures, which is exactly why the material decision belongs in the RFQ rather than in a follow-up email.

Related: the plastic bird spikes specification guide shows how to write these requirements into a standard RFQ format, and the inspection checklist shows how to verify them on a batch.